Error codes on oven
5 min read
Is there an error code on your oven? Find out what different error codes mean.
(Scroll across for more information)
| Code | Description | Actions |
| ERR1 | Cooking chamber temperature not measured. Deffective sensor. | • Check the connector from the temperature probe of the cooking chamber is inserted correctly in its counterpart located on the electronic card. • Check the probe wires. • If the defect persists, replace the probe. • After a functional check of the oven, if the defect persists, replace the electronic programmer. |
| ERR2 | ||
| ERR3 | Signals from encoder not detected. Encoder or its connection is deffective. | • Check whether the connectors of the connecting wire between the encoder (a special electromechanical device located on the back of the selector) and the card EL1100 are correctly inserted in their counterparts. • Try replacing the encoder. • Replace the electronic card. |
| ERRP | Door lock problem. Observe whether the lever for locking moves freely. |
• Check the mechanical kinematism. The lever must move freely back and forth. If it seizes, try replacing the door lock. • Check whether the electrical connections are correct, as shown in the electrical diagram. • Check whether the 3-way connector (white) from the door lock is connected to the electronic card. |
| F1 E2 | No internal sensor reference | • Replace programmer. |
| F3 E0 | Sensor Open Only for version with probe PT1000 code 1170000815-0 (piro oven) Sensor Short-Circuited Valid for version with NTC probe code 1170000843-0 (multi-function electrical ovens, not piro) |
• Check whether the connector of the probe is properly inserted on the counterpart located on the programmer. • Check the probe wires. • If the defect persists, replace the probe. • After a functional check of the oven, if the defect persists, replace the electronic programmer. |
| F3 E3 | Sensor Short-Circuited Only for version with probe PT1000 code 1170000815-0 (piro oven) Sensor Open Valid for version with NTC probe code 1170000843-0 (multi-function electrical ovens, not piro) |
|
| F4 E0 | Femrop Error | • Replace programmer. |
| F5 E2 | Door lock problem. Observe whether the lever for locking moves freely. |
• Check the mechanical kinematism. The lever must move freely back and forth. If it seizes, try replacing the door lock. • Check whether the electrical connections are correct, as shown in the electrical diagram. • Check whether the blue wire inserted on connector P5, located on the programmer, is properly inserted. |
| F8 E0 | Potentiometer Error | • Check the wiring of the potentiometer (power resistive value 10 Kolm). • Check if the connectors are properly connected (The connectors are polarised) • Reset the displayed error by pressing the 'Mammal' key. Wait for a time T of not less than 2 minutes. If the defect persists replace the programmer. |
| FF FF | Unknown problem. | • Replace programmer. |